Mould test chamber

lp2010

	Purpose
	This product is applicable for the testing of the indices of the spaceflight and aviation products, materials, electronic products,(linpin) and electronic and electrical components and parts in humid and heat environment.
	Chamber Structure
	The inner bladder of the chamber is made of imported SUS304 stainless steel plate while the outer bladder is made of A3 steel plate sprayed with plastic. A large observation window is set on the chamber door(linpin). Double-layer high-temperature resistant and high-intensity seal is adopted between the chamber door and the chamber body in order to ensure the obturation of the testing area. A test hole with 25mm,(linpin) or 50mm or 100mm diameter is set on the left of the chamber body. A high-quality fixable PU moving wheel is adopted on the bottom of the test chamber.
	Cooling and Air Duct System
	The cooler adopts original French Tecumseh fully-closed compressor. The cooling system adopts single or dual low-temperature loop system design. Air speed ≤0.2 m/sec (linpin)
	Standards Applied
	GB/T10588-2002
	Specs & Technical Parameters
	Model (CM) (J)MS-100 (J)MS-225 (J)MS-500 (J)MS-010 Workroom Dimensions 45*45*50 50*60*75 70*80*90 100*100*100 Exterior Dimensions 105*97*176.5 105*102*200 132*132*217 167*152*231.5 Power 4.5(KW) 5.5(KW) 8.0(KW) 13.5(KW) Temperature Range 20℃~80℃ Humidity Range 45~98%R.H Fluctuation/Evenness ≤±0.5℃/≤±2℃ Humidity Deviation + 2, －3%R.H

derect

顶一个人了。。。。

lalabadboy

这是神马东东