标题: 跌落测试 [打印本页] 作者: davidke 时间: 2007-5-28 13:01 标题: 跌落测试 请问有谁知道跌落测试标准作者: roychen 时间: 2007-5-28 14:11
Please go to my space and consult the "Packaged-Product Drop Test&Impact Velocity Standards".作者: ming 时间: 2007-6-28 10:33
1,跌落方式：一角三边六面
2跌落高度与重量
重量 高度
1－20.99磅（0.45－9.5KG） 76.2CM
21-40.99磅（9.55－18.63KG) 60.9CM
41-60.99磅（18.64－27.72KG) 45.5CM
61-100磅 （27.73－45.45KG) 30.5CM作者: liuqiugen 时间: 2007-7-6 17:59 标题: 回复 #1 davidke 的帖子 請問你要的是玩具的跌落測試的標準? 如下:
EN:最嚴格的方向 850mm 跌落5次.
ASTM-F963: 0-18 Months 4.5ft, 10 drops
19-36months 3.0ft, 4 drops
37-96 months 3.0ft, 4 drops作者: andyzhao 时间: 2007-7-6 19:08
不知道你要什么的试摔标准,MTL,BV,JCP??作者: peterdengzb 时间: 2007-7-20 21:07 标题: Drop test instruction Rules
1. No refusal from vendor on the drop test is accepted.
2. Supplier have to provide the appropriate cartoon in order to protect the goods
Objective
Check the reliability of packing and carton quality.
Ensure the safe transit of products.
Test condition
a) Carton quantity tested:
Sampling size: S-1
b) Test surface:
Flat rigid concrete floor
c) Drop Height for non fragile goods Drop test for fragile goods
Toys, EM, Garden tools … Glass or porcelain
Gross Weight Drop height Gross Weight Drop height
0-10kg 80cm 0-10kg 25 cm
10-30kg 50cm 10-30kg 25 cm
Over 30kg 25cm Over 30kg 25 cm
d) Drop sequence
1. Test the most fragile corner, if not known, test the
bottom manufacturer’s joint corner
2. Test the bottom face
e) Carton should withstand the maximum static pressure in shipping container
Product scope:
These drop test applies to the export carton of all products
Note: Not applicable to packed products on a skid or pallet secured together as a single load.
Inspection Points after Test as Usual Inspection:
1, Package of sales unit
2, Safety, function and appearance of the product
Criteria
No critical defect allowed. The master carton still affords reasonable protection to the sales unit.
Operation guideline
If critical defect emerge after test, the PSI report is failed. Major defect found after drop test should be marked as pending in the PSI report. Minor is acceptable. The defect quantity and ratio should be mentioned in the report.作者: Mary 时间: 2007-7-21 21:18
一般我们电器的是：ISO2448,不过没有现成的