验货员论坛

标题: 求关于划痕方面的标准 [打印本页]

作者: yvonne007    时间: 2012-5-28 16:14
标题: 求关于划痕方面的标准
求关于划痕方面的标准,谢谢大虾指点
作者: yvonne007    时间: 2012-5-28 16:17
自己顶一下
作者: Denny.Xie    时间: 2012-5-28 21:36
1-2mm算MInor .2mm以上算Major
作者: mike_zhang    时间: 2012-5-28 22:01
原帖由 Denny.Xie 于 2012-5-28 21:36 发表
1-2mm算MInor .2mm以上算Major

是指长度吗?
作者: 验货讲原则    时间: 2012-5-28 22:45
Acceptable Tolerances: Major defect: More than 1/2" in length for flat scratch, or more than 1/4” in length for
depth and width scratch, equal or more than 3 scratches on the whole outside surface; Minor defect: Between 1/4“
to 1/2” in length for flat scratch and less than 3 scratches, or between 1/8” to 1/4” in length for depth and width
scratch and less than 3 scratches on the whole outside surface. The Major acceptable tolerances on
outside/visible area can be considered as minor defect on inside/hidden part; The Minor acceptable tolerances on
outside/visible area can be considered as acceptable on inside/hidden area.
How to Measure method: The scratch length measurement should follow the curve, and not straight measurement. That is to say, measure the curve length along with the scratch instead of the beeline length from the start point to the end point. The width and depth is judged by QC’s subjectivity.
作者: roy.zhu    时间: 2012-5-29 17:30
看实际情况,依据实际产品,杂货超过2MM就是Major工厂都不用做了
作者: ZHENGALVIN    时间: 2012-5-30 15:13





欢迎光临 验货员论坛 (http://bbs.wtoqc.net/) Powered by Discuz! X3.2