|
Perform the drop test, in according with height prescribed on point 5, in the following sequence;
|
1
| Test the corner of most fragile face that is near to the manufacture’s joint.
|
2
| The shortest edge radiating from the corner tested.
|
3
| The next Longest edge from the corner tested.
|
4
| The Longest edge from the corner tested
|
5
| Flat on one of the smallest face.
|
6
| Flat on the opposite small face.
|
7
| Flat on one of the medium faces.
|
8
| Flat on the opposite medium face.
|
9
| Flat on one of the largest faces.
|
10.
| Flat on the opposite large face.
|