2. FUNCTION TEST Qty Pass Fail N/A
A) Dielectric Withstand Test 20 X
- Withstands without breakdown a potential of 1000vac / 5mA (1000vac + 2 times the rated voltage for
units rated more than 250V) applied for 1 minute between live parts and any noncurrect-carrying
B) Strain Relief Test: (for Power Supply Cord) 3 X
- The strain relief device withstands a 35lbs pull force applied for 1 minute in any direct without
transmitting the pull to terminals, splices or internal wiring.
(RESULTS - There is to be no displacement of nor strain transferred to that portion of power supply
cord internal to the test sample.)
C) Stability Test 3 X
- Moveable heater returns to its intended at-rest postion on level surface when tipped in any
direction at an angle 10 Degree to the horizontal
D) Glass Panel Impact Test 3 X
- A glass panel or similar brittle material employed in a heater withstands, without cracking
or breakage, an impact producted by swinging a 2 inch diameter steel sphere weighing toughened glass:377mmX357mmX5mm
1.18lbs from a height of 16.15inches. plastic panel:371mmX279mmX2.5mm
(The panel, while in fully heated conditsion, does not crack or break when a wet cloth is wiped
across the surface or when sprayed with a fine mist of cold tal water.)
5) Switch Durability: (Switches must withstand 100 Cycles of use w/ no failure) 3 X
7) Light Bulb Life Test (For B10 - 40W) 3 X
- Input Power (162Vac / 50Hz) REMARK:
8) Overrall Appearance 20 X
- No major defect, no loosening of parts/ component, well painted, no burrs, cracks or dents
9) Construction 3 X
- All component shall be UL/CUL and CSA recognized
10) Workmenship 20 X
- Good finish, no sharp edge, no sharp point, properly fitted
- All feet can be assembled well and level
- Door is properly assembled, can be opened and closed normally
- Glass window is properly fitted
- Clip holding glass window is assembly properly作者: leozheng 时间: 2011-3-4 11:19
路过~~~~~~~作者: MS168 时间: 2011-3-4 16:51
路过~~~~~~~