验货员论坛

标题: toys inspection on site test [打印本页]

作者: wzh202    时间: 2007-6-23 22:46
标题: toys inspection on site test

Toys inspection on site test

1.
Small part/small ball:













2.

Small part warning: 3 years up to 6 years

Small ball warning: 3 years up to 8 years



3.
Sharp point










4.
Sharp edge














5.
Rigid Projections (under 8 years)

·
Applicable: both before and after abuse testing

·
Only vertical or nearly vertical projections are required to be evaluated

·
Do not apply corners of structures


6.
Circular Holes in Rigid Materials: 5 years or less

Thickness: <0.062in.(1.58mm)
Depth: 3/8in.(10mm)
admit &frac14;in.(6mm) ~1/2in.(13mm)



(Rigid materials: hardness exceeding 70 Shore A scale durometer)


7.
Hinge Line Clearance: 5 years or less

Moveable portion: &frac12; lbs and above
0.19in.(5mm)<gap<0.5in(13mm)


8.
Surface coating (adhesion test)
1/16 inch,
make 9 straight parallel cuts
135 degrees



9.
Abuse test:

Torque test: 0~18 month
2 ± 0.2 in-lbs


18 m~36 m
3 ± 0.2 in-lbs


36 m~96 m
4 ± 0.2 in-lbs

Tension test: 0~18 month
10 ± 0.5 lbs


18 m~36 m
15 ± 0.5 lbs


36 m~96 m
15 ± 0.5 lbs


Seam
15 ± 0.5 lbs

Compression test: 0~18 month
20 ± 0.5 lbs


18 m~36 m
25 ± 0.5 lbs



36 m~96 m
30 ± 0.5 lbs

Bite test:
0~18 month
25 ± 0.5 lbs

(CPSC)

18 m~36 m
50 ± 0.5 lbs


mouth contact:
100 lbs

Flexure test: 0~18 month
10 ± 0.5 lbs




18 m~36 m
15 ± 0.5 lbs



36 m~96 m
15 ± 0.5 lbs



(total: 30 cycles, 2 sec/cycle,
+/-60 degrees)

Drop test:
0~18 month
54 inch
10 times
<3 lbs


18 m~36 m
36 inch
4 times
<4 lbs


36 m~96 m
36 inch
4 times
<10 lbs


For example: under 3 years 2.5 lbs
Need do what?




10.
Sound level test:
25 cm

Handheld, tabletop, floor and crib toys----Continuous Sound Level<90 dB(A)
Close to the ear toy---- Continuous Sound Level<70 dB(A)
All toys, Impact type----Impulsive Sound<120 dB(C)
eg: Rattles

All toys, Explosive type---- Impulsive Sound<138 dB(C)

(Test Environment: at least 1m from any wall and background noise level 15 dB lower that sound being measured)


7. Battery operated toys test:
a. Check Battery Identification(battery type,voltage,orientation&polarity)
b. Possibility of charging primary battery(3 batteries and above)
c. When product is under 3 years: Batteries shall not be accessible without use a tool during normal use and after abuse.
d. Short Circuit: inadvertently or intentionally short circuit is not exhibit without using tool during normal use and after abuse
f. Leakage current test

g. Maximum voltage: 24 V DC
h. Battery surface temperature: < 71 °C
i. Single electrical circuit: Should not mix different types or capacities of battery.

11.
Cords and Elastics:



作者: 广州验货员    时间: 2007-6-30 21:34
好贴,置顶!
作者: roger66    时间: 2007-7-2 13:36
标题: 好啊
THIS IS A VERY VERY GOOD IDEA!
作者: luckyman    时间: 2007-8-29 15:50
You should say this in a guideline of on site test of ASTM
作者: nickliu    时间: 2007-9-28 09:20
不错啊!
作者: jonelychen    时间: 2007-9-28 11:33
不错,顶一下.呵呵
作者: guyabi123    时间: 2007-9-28 13:06
SUPPORT YOU! THANK YOU!
作者: roger86751770    时间: 2007-9-30 11:48
thank you very much indeed
作者: 185646842    时间: 2007-9-30 13:59
thank you ,it's very useful
作者: unioninspection    时间: 2007-11-5 21:45
you are very proficient at the toys inspection
作者: joewcl    时间: 2007-11-6 08:45
good
作者: LCMJ-WSL    时间: 2007-12-8 15:13
thanks ,i very need i t
作者: jameslit    时间: 2007-12-17 19:01
标题: 回复 #1 wzh202 的帖子
good,thanks
作者: jameslit    时间: 2007-12-17 20:31
标题: 回复 #1 wzh202 的帖子
good,thanks
作者: tonykwok    时间: 2007-12-17 22:27
SUPPORT YOU!
think you!!
作者: luolianggood    时间: 2008-12-6 20:23
标题: 谢谢分享
谢谢分享谢谢分享
作者: FSEtiger    时间: 2008-12-8 16:06
不错!顶下




欢迎光临 验货员论坛 (http://bbs.wtoqc.net/) Powered by Discuz! X3.2